Stainless Vs. Aluminum

[leaveitalone84]

Audiophiles and interestingly Coil Gun researchers talk about this a lot. Magnetic flux gets changed lots with whats around it.

For instance if you put a Iron pipe around a barrel + coils of a coilgun/gaussgun it will increase the amount of magnetic flux into the projectile; thereby increasing its ability to do work.

Logically it makes sense that changing the field of an audio transformer would change the frequency response and efficiency of the amp.

[v846]

Wow that's some sexy SS!

Ditto ! Yeah that's a beauty

FWIW not a guitar amp but the old Sonny Jr. amps used stainless as well...

[mhuss]

I used SS for exactly one build, because I got the chassis as a gift. It was pre-punched, but the few holes I did need to make were a royal PitA. I would not do it again except 100% prepunched!

[img:512:296]http://mhuss.com/Hiwatt/DIY/MHUSS100.jpg[/img]

--mark

[Structo]

Larry you certainly go the extra mile with your amps!
Just beautiful craftsmanship!

[Tubetwang]

I'm a sucker for German Engineering...
Larry's amp are beautiful to say the least!!

My Dynaco ST-70 has a Stainless chassis.

Triode Electronics already sell Dyna Repro chassis for 120-140$ each...they should jump in and move some stainless chassis for rock and rollers...

[novosibir]

Wow that's some sexy SS!

Ditto ! Yeah that's a beauty

Just beautiful craftsmanship!

Larry's amp are beautiful to say the least!!

Wow, so many flowers

Thanks guys for your kind words!

Larry