For M FOWLER About Budda TwinMaster MV Mod....

[zozoe]

Hiya,, this question goes back to January when I initially inquired about putting a decent MV in my Twinmaster combo... So, is does the picture attached along with this laundry list, tell me all my tech would need to know? Could I get some better written direction, as I'm afraid he may not make heads from tails, bot being a musician, & not having original schematics? Many thanks, Kenny

input Hot CH
directly to V1 pin2
V1 pin1 100k plate load, 22nF coupling cap
V1 pin3 10k//680nF (in series with 10k?)
to Normal CH and 1M log Vol pot
directly to V1 pin7
V1 pin6 100k plate load
V1 pin8 1k5//22uF
Bass&Treble EQ
V2 configured as LTP PI with 82k and 100k on the plates, 470 2k7 100k on the cathodes
2x 10n to 100k to power amp

[M Fowler]

If you must have a master volume just make a small box with volume pot and two 1/4" jacks and plug into the effects loop.
I built the one below for a Fender Hot Rod Deluxe effects loop.

60354255_10213268646022259_6798268875436720128_n.jpg

The greatness of this amp is it's powerful output section with cascading input stages.

Mark

download (2).png

BUDDA2.jpg