easier PPIMV (Post-Phase-Inverter-Master-Volume) ?

[jamme61]

Is it possible to just bleed off signal between the phase inverter coupling caps and the bias resistors? So instead of removing the bias resistors and adding a dual gang pot- I could just bleed off signal with two resistors to ground.(value to be determined) I'm asking not telling, stupid idea? would it work?

[xtian]

That's a common MV. Type 3 in Ken's Trainwreck pages:

http://www.blueguitar.org/new/schem/tra ... _pages.pdf

[jamme61]

Yea I've used type 3 but that is canceling the two sides out to lower the volume. I wanted to send the signal to ground- I guess I'm confused about this.

[matt h]

(deleted)

[V2]

like this:

[img1473]http://music-electronics-forum.com/atta ... -tubes.jpg[/img]

[matt h]

(deleted)