Implementing reverb?

[Mark]

I'm wishing to put reverb into a Bassman 100, I'm going to put Skyliner tone controls in the amp. As far as reverb goes I like the look of the ODRS V2 circuit, though I don't see where the dry signal comes from.

Edit found another circuit diagram here.
https://tubeamparchive.com/download/file.php?id=24125

I think I'd prefer to use a Dumble circuit over the typical Fender circuit, but I could be proven wrong too.

Look forward to your advice.[/url]

[M Fowler]

Henry from Redplate posted about a Super Reverb conversion here is his schematic.

Mark

[Mark]

Thanks Mark I hadn't seen this circuit.

[M Fowler]

Finally found henry's thread:

https://tubeamparchive.com/viewtopic.ph ... per+reverb

[Mark]

Thanks again Mark, that is very handy!