background noise

General discussion area for tube amps.

Moderators: pompeiisneaks, Colossal

Post Reply
sdorer
Posts: 46
Joined: Sat Jan 31, 2009 4:46 am

background noise

Post by sdorer »

I walked into some real nice 15 inch speakers so I built a 5E3 to push one of them. It sounds great but I have some intermittent background noise, it sounds like hiss/white noise that goes for a few seconds then stops. Throughout this noise the guitar sounds rich and clear, no effect on output. Any thoughts where I could start looking? Your help in past issues have been very helpful and tautght me a lot. Thanks for your efforts.
User avatar
xtian
Posts: 7263
Joined: Mon Apr 19, 2010 8:15 pm
Location: Chico, CA
Contact:

Re: background noise

Post by xtian »

Do you still get this noise with cable UNplugged from the amp? Let's try to determine if it's an internal or external noise.
I build and repair tube amps. http://amps.monkeymatic.com
Tone Lover
Posts: 261
Joined: Tue Apr 27, 2010 4:39 am
Location: Everett Wa.

Re: background noise

Post by Tone Lover »

I had this problem once went through every solder joint replaced caps resisters finally hit the right cold solder joint fixed the problem.
It was my first build tought me alot about trouble shooting and soldering .

Along the way others shared there problems with bad caps and a few bad resisters that caused the problem for them.
No fun my friend .
Bill
User avatar
Structo
Posts: 15446
Joined: Wed Oct 17, 2007 1:01 am
Location: Oregon

Re: background noise

Post by Structo »

Roll a few tubes through V1 to see if it changes.
Tom

Don't let that smoke out!
sdorer
Posts: 46
Joined: Sat Jan 31, 2009 4:46 am

background noise

Post by sdorer »

Noise does ocur without cable plugged as well as with cable plugged in.
User avatar
Structo
Posts: 15446
Joined: Wed Oct 17, 2007 1:01 am
Location: Oregon

Re: background noise

Post by Structo »

Make sure your input jack is shorting to ground when not plugged in.

Strange that it would be intermittent.
Is this a new build?

Check all grounds and solder joints.
Tom

Don't let that smoke out!
Post Reply