Yargh
I'm trying to scope some issues with a new build. The last time I used the scope it was fine but this time the wave form is crammed over to one side. There isn't a horizontal adjustment (or at least, one identified as such) on the panel. Anyone seen this before?
Thanks, Skip
Scope horizontal centering problem
Moderators: pompeiisneaks, Colossal
-
Luthierwnc
- Posts: 998
- Joined: Sat Feb 18, 2006 10:59 am
- Location: Asheville, NC
Scope horizontal centering problem
You do not have the required permissions to view the files attached to this post.
-
Cliff Schecht
- Posts: 2629
- Joined: Wed Dec 30, 2009 7:32 am
- Location: Austin
- Contact:
Re: Scope horizontal centering problem
There is a "position" knob on your scope, it's two knobs over from the big one on the top left (two over from the time scale knob). It's labeled with lines pointing left and right horizontally too. Turn that sucker to the right and see if that fixes your problem.
Cliff Schecht - Circuit P.I.
-
Luthierwnc
- Posts: 998
- Joined: Sat Feb 18, 2006 10:59 am
- Location: Asheville, NC
Re: Scope horizontal centering problem
oops! missed that one. Thanks Cliff, sh