moose trannies wiring question

[wsaraceni]

Im pretty sure i have the power done correctly.

yellow to wires on the board.
black i have going through the pilot light onto the power switch.
brown white to ground
red yellow to ground
brown to pin 2 and pin 7 on el34 sockets.
everything else ill heatshrink the end so it doesnt touch.

can someone verify that this is correct?

also, i need to know where all the output transformers get cabled up to.

once this is complete, i have very little left before first powerup!!!

thanks
bill

[joe6v6]

Yea your power trans hook up is good, in case you didnt see it here is the wiring info for the tone slut trannies http://www.toneslut.com/transformers/tr ... agrams.gif
did you get the output trans with dual primary?

JOE

[wsaraceni]

yes. i got the dual primaries. had the link, just dont 100% know where the stuff goes. grey yellow red and black on the one side go to the impedence selector is suppose.
where does blue/white and brown/white and the red on the primary side go? red to B+??. im guessing blue/white and brown/white go to the power tubes.


i guess the easier thing to ask is what do the pins on the power tubes equate to. then i can figure it out myself.