Very neat! Nice work!dynaman wrote:Just click on the myspace link below.PCollen wrote:I've never seen an amp where the PI circuit on the board (bias R's, plate R's, and coupling caps) is close enough to the power tubes to allow that. But I'd like to, and think it would be a great design. Got any pic's ?dynaman wrote:Some folks just spin the PI circuit 180 so the grid resistors go right from the caps to the tube sockets. No wire necessary.
Do You Twist Your Wires from Bias Resistors to Power Tubes ?
Moderators: pompeiisneaks, Colossal
-
azatplayer
- Posts: 556
- Joined: Thu Feb 26, 2009 7:59 pm
- Location: Great Southland