Finally started on my variant of an ANWL aka TR JM Sig. This build will be quad 6V6 powered. The chassis prep is done, minus a hole near the PT for the main ground.
* Heyboer PT and choke
* Marvel/MCI reverb and output transformers
* Tungsol RI 6V6GT
The target B+ voltage is around 410-415 from 123V mains.
BTW, I didn't really want to post in the Dumble section. I personally would like to see a sub section of variants since TR's are not really pure Dumble circuits.
TM
New Build in Progess: JM Sig 44 6V6
Moderators: pompeiisneaks, Colossal
New Build in Progess: JM Sig 44 6V6
You do not have the required permissions to view the files attached to this post.
Re: New Build in Progess: JM Sig 44 6V6
4 x 6V6 Yummy!! 
-
JazzGuitarGimp
- Posts: 2357
- Joined: Mon Jul 23, 2012 4:54 pm
- Location: Northern CA
Re: New Build in Progess: JM Sig 44 6V6
Did you get your chassis from Taylor? it looks a lot like the one I just bought from him. i'm planning a single-channel, 2 x KT66 with active EFX loop and Belton digital reverb. About 40-ish watts. I picked up an 8k OT from Rooster for the build. Looking forward to following your built.
Lou Rossi Designs
Printed Circuit Design & Layout,
and Schematic Capture
Printed Circuit Design & Layout,
and Schematic Capture
Re: New Build in Progess: JM Sig 44 6V6
Yes, maybe 3-4 years ago. Him posting his layout gave me an excuse to get it out the attic....lol
TM
-
dcribbs1412
- Posts: 1386
- Joined: Wed Jun 11, 2008 6:56 pm
- Location: Arizona Desert
Re: New Build in Progess: JM Sig 44 6V6
Looking good TM
Subscribed
D
Subscribed
D
Re: New Build in Progess: JM Sig 44 6V6
Looks great I was thinking about a Robben Ford 102 quad 6v6 what layout did you use?