Smallest practical enclosure for a D-Lator

[MakerDP]

Cool thanks.

[talbany]

Henry Heisthl did one also that was quite small and looked great.

https://ampgarage.com/forum/viewtopic.php?f=5&t=4748

Another variant from Henry...

RP_lator.JPG

I also built one of these as well works great! here is the layout Henry posted way back

RP_lator.JPG

Small FX loop.jpg

Small FX Panel.jpg

Tony

[MakerDP]

That's very helpful. Thanks for the layout!

[Mr. dB]

Henry Heisthl did one also that was quite small and looked great.

https://ampgarage.com/forum/viewtopic.php?f=5&t=4748

Another variant from Henry...

RP_lator.JPG

I also built one of these as well works great! here is the layout Henry posted way back
RP_lator.JPG

Small FX loop.jpg
Small FX Panel.jpg


Tony

Are larger images available?

[talbany]

Another variant from Henry...

RP_lator.JPG

I also built one of these as well works great! here is the layout Henry posted way back
RP_lator.JPG

Small FX loop.jpg
Small FX Panel.jpg

Are larger images available?

I have no Idea. Here is the post I got it from Henry at Red plate amps. I used these JPEG's to build my board and print my plates no problem.

https://ampgarage.com/forum/viewtopic.p ... hilit=loop
Tony

[M Fowler]

Ceriatone's Klein-u-lator is designed by the original designer not Ceriatone.

Oh yeah I'm totally aware of that. Is there anything Ceriatone does that isn't a copy of something else? Not that it's totally a bad thing...

No the designer of the Klein works in conjuction with Ceriatone to produce the product.

[MakerDP]

Yes the pics in the link to the original thread are MUCH better. They are higher resolution so you can blow them up nicely and still see all the detail.

I think I have everything I need for this except the choke and the box.

Thanks again!

[drew]

Yes the pics in the link to the original thread are MUCH better. They are higher resolution so you can blow them up nicely and still see all the detail.

Note the discussion toward the end of that thread about changes that Henry made; I don’t think the board diagram was updated.

[MakerDP]

Thanks for the heads-up.