Ok, so I asked once, then tried doing a few days of research, but im still lost in the sauce...lol. So far, in my quest to learning to build tube amps, and my schooling for electronic engineering, I understand alot more than i did say, 6 months ago. Now I can look at a schematic, get a good idea of whats going on, understand all the parts (resistors, caps, ect ect) but I still cant figure out how to take a schematic, and know how to layout my board? For example. I have the schematic to build a dumblator, and there is a pic of a board ready to install parts on here ( https://tubeamparchive.com/viewtopic.php?t=4084 ) but how do I make that board based on a schematic? Any help in understanding this would be greatly appreciated... Thanks everyone!
Justin
Board layout......Please help!!!! lol
Moderators: pompeiisneaks, Colossal
-
soloist4hire
- Posts: 9
- Joined: Mon May 19, 2008 8:23 pm
- Location: Winston-Salem NC
- Contact:
Re: Board layout......Please help!!!! lol
soloist4hire,
Try look at this tread and the schematic to see how they layed the components on the board and then layout the turrets and jumper wires under the board to make the circuit function. It is not easy and I still have a lot of trouble trying build my own turret boards or PC boards for SS applications.
Mark
https://tubeamparchive.com/viewtopic.ph ... c&start=45
Try look at this tread and the schematic to see how they layed the components on the board and then layout the turrets and jumper wires under the board to make the circuit function. It is not easy and I still have a lot of trouble trying build my own turret boards or PC boards for SS applications.
Mark
https://tubeamparchive.com/viewtopic.ph ... c&start=45