DPST 3 Position (Play-Stdby-Off) wiring Question

[wattsup]

I am wondering if I got a Carling DPST, Toggle, 3 Position, (Play-Stdby-Off), would it be wired like this? If not, what would be correct?

[ToneMerc]

I assume you are talking about this particular switch.

https://d1sjrnpi226dnf.cloudfront.net/s ... 1382030369


TM

[wattsup]

I assume you are talking about this particular switch.

https://d1sjrnpi226dnf.cloudfront.net/s ... 1382030369


TM

Yes I believe that's the same one. http://www.tubesandmore.com/products/P-H520

That wires a lot differently than I had thought. Thanks ToneMerc!

[ToneMerc]

I assume you are talking about this particular switch.

https://d1sjrnpi226dnf.cloudfront.net/s ... 1382030369


TM

Yes I believe that's the same one. http://www.tubesandmore.com/products/P-H520

That wires a lot differently than I had thought. Thanks ToneMerc!

YW and yes it appears to be. The several I have used came from TD, but I'm sure it's the same switch.

TM

[wattsup]

I assume you are talking about this particular switch.

https://d1sjrnpi226dnf.cloudfront.net/s ... 1382030369


TM

Yes I believe that's the same one. http://www.tubesandmore.com/products/P-H520

That wires a lot differently than I had thought. Thanks ToneMerc!

YW and yes it appears to be. The several I have used came from TD, but I'm sure it's the same switch.

TM

So like this?

[wattsup]

Or would I want the PT and 110v flopped? Or does it matter?

[wattsup]

Ok after looking at it for a while I think the lights finally came on I think this is correct.

[Phil_S]

Sorry to be the odd man out, but why do you want a standby? It isn't needed. Just switch the mains on and off. Simple. Takes care of everything in one flick.