TINA oscilloscope problems

[surfsup]

I am trying to run this on a design in TINA. I have a sine wave at the input, three 12ax7 triodes and a CC and Resistor in series to ground after the last triode as a load. I have an "out" from the junction of the cc/R to ground. I start the oscilloscope and it defaults to out1 and when I hit run, it just sits there "collecting data". I updated TINA and have been fiddling with this for 40 mins. I don't understand what is wrong. AC transfer characteristics are fine. I tried auto/normal/single modes. Anyone use TINA and know what I am missing?

[surfsup]

Geez, figures. A minute after I post I figured it out...

[Structo]