jtm 45 with Marstran transformer set

[dukeamps]

Hi everyone, i was just messing about with my jtm45 i have built, it has about 10 hours on it so far. Has marstran trannys sozo caps cc resistors,
preamp tubes are rft & poweramp tubes are gold lion kt66s.

Done a quick demo, i would be grateful on any feedback on how it sounds.

clip http://soundclick.com/share?songid=9316590

Thanks

Dukeamps

[rbryerton]

Sounds very nice! Give us a few more details on the recording:

What input(s) did you use (high/low/I or II/jumped)

What were the volumes set to. What's your recording chain?

I like it!

[dukeamps]

Sounds very nice! Give us a few more details on the recording:

What input(s) did you use (high/low/I or II/jumped)

What were the volumes set to. What's your recording chain?

I like it!

Hi, Thanks for answering Rob. I recorded it with a sm57 beta turned 90 degrees from the speaker face, about 10cm from the speaker, and inbetween the inner rim, and outer rim of the speaker. Guitar is a tokai 150gt les paul. The amp was on the bright ch only, vol 8 tre 8 mid 10 bass 2 pres 8, i used the guitar vol for vol control. I haven't used any fx just guitar & amp.

Thanks
Dukeamps

[dukeamps]

Hi, So i have done another clip, but this time i have new pickups from Häussel, they are made in Germany, and i have also bought a new mic, it is a sennheiser e606.
In the clip i have the amp at 10, and used the vol on the guitar.

I would be glad of any feedback.

Clip Jtm 45 Marstran tranny set, Tokai les paul with häussel pickup. http://soundclick.com/share?songid=9398876

Thanks

Dukeamps