super100 wrote:
I purchased that set of boards.
Here is a picture of the board from the layout that you posted.
Do you have the layouts for the other two boards that were part of the set?
By the way, great job on the build.
Thanks,
Henry
Thanks Henry and thanks again for the cab.
Here ya go, all four.
Mike
Mike,
That was quick!
Thanks for taking the time to do that and hope you enjoy the cab.
boldaslove6789 wrote:
Me and Jim Price (Groovtubin) were just talking about this the other day.
Darn HRM's are so finicky but plate B+ is soo key.
This sure is the truth. The lower B+ on V1 just was not happening either, really didn't start to come around until I got V1 up closer to 190V and V2 down into the lower 190's. The OD TS is 8.7K, 228K and 94.5K with still lots of tuning left, but good enough to go into one of Taylor's head cabinets. Actually I think I prefer it with the OD TS lifted, that boost effect is much better than the normal PAB. The HRM starts to sound much better when the OD master is up around 5.
V1 JJ83S= 187.7/188.5
V2 JJ83S = 190.6/192.6
V3 LPS 12AX7A = 272/278.5
V4-V7 = TS RI 6V6
Plates = 390
Screens = 388
Bias = 23
TM
You do not have the required permissions to view the files attached to this post.
I must say that amp looks great all dolled up. I might be biased (if you will) but I built that cab long enough ago to be somewhat impartial. Great work TM..man you have been busy
