Faceplates for Hammond 16x8x2 chassis

[IcemanB52]

Attached are CorelDraw 4 files I used for my faceplates. I order these at http://www.bnplasers.com/. I've ordered 3 sets and their service is very good. Only drawback is that they use CorelDraw, which is not a widely used program. Cost for front and back was around $55.

[markusw]

Attached are CorelDraw 4 files I used for my faceplates. I order these at http://www.bnplasers.com/. I've ordered 3 sets and their service is very good. Only drawback is that they use CorelDraw, which is not a widely used program. Cost for front and back was around $55.

Thanks a lot! Your amp looks fantastic. Wish I could do wood work.
Is here any setup fee for the faceplates or in other words does it make a difference whether buy one set or three?

Peace,

Markus

Edit: I also like the outcome of home made Bungard Alucorex faceplates (see below)
If you're doing 3 pairs of plates it's pretty cheap. If you just do one set of plates out of a ~19x19" Alucorex plate like I did it's probably in the same league as the bnp plates. Problem is you also need tools to properly cut the stuff. I had to go to a local shop. They charged roughly $2 for one cut.

[IcemanB52]

I don't think there is a setup fee, but double check their web site for current pricing. Your amp looks great! Where did you find the schematic to add reverb?

[markusw]

I don't think there is a setup fee, but double check their web site for current pricing. Your amp looks great! Where did you find the schematic to add reverb?

It's Gary's single tube reverb:
https://tubeamparchive.com/viewtopic.ph ... ght=reverb