What would be the best way to secure my chassis to my cab?

[noworrybeefcurry]

I just recently had a chassis made for my build, but I did not drill any cabinet mounting screws yet because I wasn't sure how everything was going to sit in the amp. I have a much better idea of the dimensions inside of the amp now. But the chassis itself is very large-3" high, and the lip is long ways across the chassis. So basically about the pots and switches and whatnot-probably not the best idea in hindsight.....oh well. But I was hoping someone might have some insight as to what the best way to secure the chassis would be? Do I need those clips that slide over an open hole and allow a screw to be threaded?

[dreric]

These work better.

http://www.ebay.com/itm/Aircraft-nutpla ... 43a81f28ce

A photo would be helpful.

Eric

[amplifiednation]

Throw a picture up. I might have an idea. Need to know how the amp sits (top or bottom cab) and what kind of cabinet you intend on putting it in...will it have a crossbar? There's a lot of tricks with trim that you can do to keep it very professional while at the same time securing your chassis really well.

[67plexi]

Eric, Is 100% this is it.

[noworrybeefcurry]

Hey guys sorry for the late reply, school and works been a little hectic this week. Anyway here are a few pictures of my chassis.

http://s1237.photobucket.com/albums/ff464/dreamtwofly/