pacific output trans

[Roe]

I’m wondering what the test is that is showing the primary impedance to be 6.7K?

I’m only aware of a ratio test.

these ratio tests easily become a little inaccurate. It could be that the load resistor reads a little to high, for instance

[Mark]

I’m wondering what the test is that is showing the primary impedance to be 6.7K?

I’m only aware of a ratio test.

these ratio tests easily become a little inaccurate. It could be that the load resistor reads a little to high, for instance

That has been my experience too.

[Vince-]

So I contacted Pacific about the OT..
They were advertised as 7.5k
Red Series as well as USA Series.
They are relling me that the spec sheets had typos and they were 6.6k all along. someone inquired recently and they corrected the spec sheet to say 6.6k

Eventually I'll get the chance to test mine and I'll come back and confirm..

Here is a pic they sent me showing 6.7k

I'm sure one of you has had a chance to measure some at.one point or another.id be interested to hear if this info is wrong. If not I'm happy to have found out ..

I’m wondering what the test is that is showing the primary impedance to be 6.7K?

I’m only aware of a ratio test.

I'm not too sure to be honest.

[pdf64]

The red series is definitely an oversees product according to them. ...

I just noticed the site states 'built in California' https://pacificaudiomagnetics.com/pages/about-us

[johnnyreece]

The red series is definitely an oversees product according to them. ...

I just noticed the site states 'built in California' https://pacificaudiomagnetics.com/pages/about-us

Looks like they need to update that page. This one says the Red Series are "...assembled in our international manufacturing facilities..."

https://pacificaudiomagnetics.com/pages/our-series