Tube Amp Archive

sluckey wrote: ↑Sun Feb 10, 2019 8:31 pm You twist the blk and brn together and they stay together and connect to the ON/OFF switch.

You twist the Blk/wht and brn/wht together and they stay together and connect to the Neutral lug on the IEC AC power connector.

Thank you so much!

Thanks for the help . So Red goes to Pin 6 and 4 and Yellow goes to Pin 2 and 8 on the recto? My question on the primary wiring and where to wire the Blk/Brn and Blk/Wht - Brn/Wht. Do these wires get soldered to the same lug or are they split up? The Ceriatone PT Layout shows a wire from 0 going to ...

Just about to Solder Leads and could use confirmation so i don't mess it up. I've Hooked up the Green wires to the V4 and grounded the Grn/Yel and Red/Yel . According to the Diagram instructions on the bottom i should use Red-Red/Yel-Red for a tube rectifier but the verbal instructions i got were to...

Thank you !

It’s been over a decade since I’ve built a tube amp (I’ve built 7 total ) and I am having trouble remembering how to read a transformer schematic. I am using a Ceriatone kit and a Classic Tone PT #40-18054. (http://www.classictone.net/40-18054.pdf) This PT has extra leads for almost every option. I ...